Bontrager SPEED LIMIT ROAD BRAKESETS Manuel du propriétaire télécharger pdf (Page 13)

11 TREK SERVICE INFORMATION 24 May 2010

Derailleur Cables

At this point in the assembly, the cables should be in the housing that runs through the

downtube. These instructions explain the correct routing through the bottom bracket cable

guide and to each of the derailleurs.

To connect the front derailleur cable

Slide a piece of cable liner onto the front derailleur cable until the liner touches the 1.

back of the housing stop in the bottom bracket (Figure 1).

Orient the front derailleur liner grommet (Figure 2) and slide it onto the liner (Figure 3), 2.

and then snap the grommet into the frame hole in the seat tube.

Cut the liner so that it does not interfere with the action of the front derailleur.3.

Attach the cable to the derailleur and adjust as normal.4.

To connect the rear derailleur cable

From the bottom bracket cable guide, run the bare cable (with no liner) through the 1.

chainstay and out the dropout exit hole.

Install the dropout housing stop in the dropout exit hole (Figure 4).2.

Measure and cut the rear derailleur housing.3.

Install the housing, connect the cable to the derailleur, and adjust the derailleur as 4.

normal.

Figure 3. Seat tube grommet on cable liner to front

derailleur

Figure 1. Cable liner for front derailleur in bottom

bracket cable guide

Figure 4. Rear derailleur cable passing through the

dropout housing stop

Cable liner

Figure 2. Correct orientation of seat tube grommet

Drive side

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Pas de commentaire

Bontrager SPEED LIMIT ROAD BRAKESETS Manuel du propriétaire Page 13