Bontrager SPEED LIMIT ROAD BRAKESETS Manuel du propriétaire télécharger pdf (Page 11)

9 TREK SERVICE INFORMATION 24 May 2010

Insert the extension tube clamp pinch bolts (F) and tighten. 5.

Slide an arm rest bracket (E) onto the extension tube.6.

Insert the arm rest bracket pinch bolt (D). 7.

Adjust the arm rest bracket to the desired angle, and tighten the pinch bolt. 8.

Note: extreme angle adjustment might limit the ability of the arm pad holders to align

correctly.

Repeats steps 2-8 for the other side of the aerobar.9.

Tighten all the fasteners.10.

To install the arm pad holders and arm pads

The width of the arm pad holders can be customized to suit your body type and riding style.

Insert two arm pad holder screws (B) through the desired holes of an arm pad holder 1.

Two screws are required per side to prevent the arm pad holders from spinning on the

arm rest bracket.

Tighten the arm pad holder screws. 2.

Repeat steps 1-2 for the other side. 3.

Place the arm pads on the hook-and-loop fasteners of the arm pad holders.4.

To install the shifters

Install the shifters in the extensions following normal installation procedures. Do not

overtighten the clamp wedge mechanism. Do not exceed 45 lb•in (5 N•m).

Do not drill or cut the extension tubes. Tighten the shift lever mounting bolt until the shift

lever is rmly in place.

To install the brake levers

Install the brake levers following normal installation procedures. Do not overtighten the

clamp or wedge mechanisms.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Pas de commentaire

Bontrager SPEED LIMIT ROAD BRAKESETS Manuel du propriétaire Page 11